My Alphabet Quilt Blog of the Month Part 2B

I know that I said the machine appliqué lesson was next, but my machine was acting up and I had to have it cleaned and checked--thanks Kurt! So, in the meantime, I've been working on getting more blocks ready. As you can see on Amy's directions that are listed at the bottom of the placement sheets, she starts at Step 5. You have already prepared your appliqué pieces and are ready to fuse them into place.

Amy has done a terrific job giving you the order of placement for the appliqué pieces. However, I found that in some cases it helps to pre-construct some units. Place the pieces on the Appliqué Presser Sheet or the release paper from the fusible web, press in place and they will release when cool. I also have found that I like to mark some of the detail lines before I fuse the pieces together.

So, with that said, here are my hints for pre-constructing and pre-marking the first eight blocks...................

Front of bus
Pre-construct
Mirror supports and mirrors
Inside and outside of all lights
Top of bus and windshield
Bottom of bus and grills
Pre-mark
Detail lines for abc

A
Pre-construct
Paintbrush and letter a
Face and hair
Collar and bow
Pre-mark
Nose, mouth, eye position, detail lines of hair ties and bows

B
Pre-construct
Hat and brim
Face and hair
Pre-mark
Nose, eye position, bubbles, and bandage detail lines

C
Pre-construct
Camera pieces
Pre-mark
Mouth, eye, detail lines for fingers and bow

D
Pre-construct
Top of hair, headband pieces, and reflector
Face and right and left hair
Pre-mark
Nose, mouth, and eye position

E
Pre-construct
Outside and inside of earphones and earphone wire
Pre-mark
Nose, mouth, and eye position

F
Pre-construct
Frog and frog eyes
Pre-mark
Nose, frog mouth, frog chin, eye positions for girl and frog, and bows

G
Pre-construct
Goggle, goggle lenses, goggles straps, and buckle
Pre-mark
Nose, mouth, and eye position

Cut the fabric for the backgrounds
From your background fabric, cut seven strips 11 1/2". Cut each of these strips into four blocks 9 1/2" x 11 1/2". I like to treat my backgrounds with a couple layers of spray starch to make them extra crisp so that they naturally act like they have been stabilized.

Follow step 8 of Amy's directions
Read the instructions directly below the block placement sheet for any specific instructions for Step 8. On a light table, put a 9 1/2" x 11 1/2" fabric block background right side up over a block placement sheet. There should be approximately 1/2" of extra fabric around the block. Place applique pieces and/or pre-constructed units in place on fabric background aligning with placement sheet. Fuse into place.

There is lots of preparation for the applique to go smoothly, but well worh the effort. I will give you the order in which Iwill applique the pieces next as well as post photos of the actual applique process (as soon as I can find one of my 3 pairs of magnifier glasses).

Hunting for my glasses so that I can be back soon,
Lynda

My Alphabet Quilt Blog of the Month Part 2a

I'm sooooo excited for My Alphabet Quilt Blog of the Month!!!

Because there is so much to talk about this first month, I am going to break the information up into a few blogs. I have a few of My Alphabet Quilt pattern and book and two different kits to get you started. The first kit is a Skintones Kit--I have one available. It includes 4 different mottled fabrics for the faces and hands. These will be the exact fabrics that I will be using, in fact, I accidentally used the wrong side of the fleshtone fabric for my artist's face--ooops, but it turned out fine and it gave me another choice. The second kit is the background/border kit which includes the white-on-white for the block backgrounds and borders, as well as the turquoise and the red--I have a few of these available. The fabrics may change but I will try to stay true to the colors. If you would like the pattern or the kits, please email me--address below.

Getting organized:

Pre-washing your fabric is a personal choice. We hardly ever pre-wash because we start projects at work and don't take the time. I am not pre-washing my fabric and I realize that the fabrics could possibly run. I will use Shout Color Catchers when I wash the quilt and not allow the quilt to soak.

Cut placement sheets and pattern sheets apart. Set placement sheets aside for now. There are many fusible products on the market. This project requires that you have a least one side covered in paper that you can trace on. The two that I use are Wonder Under and Steam-a-Seam 2 Lite. I like them both, although SaS 2 Lite creates a better bond because there is more fusible that comes in contact with the fabric. Whatever fusible product you use, be sure to read and follow the directions on the package.

Tracing the pattern pieces:

Place your fusible product over your pattern sheet with the paper side up. Leave at least 1/4" between pattern pieces. Using a Sewline pencil in black, I trace all of the pieces from the pattern sheets onto my fusible web. I cut them out roughly--DO NOT CUT ON PENCIL LINE, but at least 1/8" away from it. I place them in a repurposed spiral notebook that I have marked with the alphabet letters, one set of pattern pieces per page.

If you want a softer feel for your appliqué blocks, trim out the inside of your fusible pattern pieces, about 1/8" inside of penciled line. I especially recommend this on any pieces that have many layers such as C is for Camera. Save these larger cutout pieces to trace smaller patterns, therefore saving on the amount of fusible that you will be needing. Be especially careful when trimming out the letters. Leave a bridge to connect the inner cutout pieces in letters such as "a and b" (see letter b below).

Some light fabrics placed over dark fabrics (such as the letter "m" where the dark fabric might show through the light skin) would benefit from lining the light fabric. To line the light fabric, iron a piece of fusible web to the wrong side of the light fabric, peel the paper off and iron to a separate piece of white fabric. Then treat this bonded fabric as one fabric. I will let you know which pieces I have lined.

Press fusible pattern pieces to fabric:

Place the pattern piece on the wrong side of your chosen fabric and press according to the fusible web instructions. Let cool. Now, cut out the pattern pieces on the pencil line. I find the Fiskar's Curved Scissors allows me to cut smoothly and accurately and can flip over to cut inside or outside curves.

Pattern Placement and Details:

This is where the Applique Presser Sheet (APS) pays for itself! Place the Letter Placement Sheet on an ironing board. Place the APS over it. Read the instructions directly below the block placement sheet for specific instructions from step 5 (refer back to the main Instruction Sheet for any steps not listed). Remove the paper backing from the fused pattern pieces. Place them in numerical oder on the APS using the placement sheet as your guide. Press as you go and the pieces will stick to the APS. When all pieces are placed, press again. Let cool. (Hmmm-I just noticed that I lost a bow for her braid-back to the ironing board).

Mark the detail lines and eye dots with a Sewline Pencil in a color that contrasts with the fabric. Peel the applique away from the APS. Place the entire piece on your background rectangle and press into place.

If you don't have an APS, lay your background fabric over the placement sheet and center it. Place your applique pieces in order on the background and press into place. A light box might be helpful for placement, but do not press your pieces on it. Mark the detail lines and eye dots as described above.

Next up, Part 2b, Applique

If you have any questions as we go along please add a comment to the end of the blog entry or email me at millilyn@aol.com.

Back at you soon,

Lynda

Christmas in July

Merry Christmas everyone! Christmas in July at Great American Quilt Factory, starts this Sunday, July 18th and goes through Saturday, July 24th. Customers in the store and online will enjoy 20% savings off of anything Christmas. What a great time to start your Christmas sewing.

Just in time for Christmas in July is our newest pattern No Peeking. This delightful wallhanging/banner is approx. 14 x 40".

No Peeking's bright colors and simple patchwork and applique make this a perfect gift.

We have a ton of Christmas fabric and Nancy and the design team have stitched up lots and lots of stitching friendly panel quilts. See some of them on the website http://www.greatamericanquilt.com/.

Also on display in the store are several of the models from our newest C&T book Christmas with Possibilities.
Christmas with Possibilities is truly a lovely book filled with 16 holiday projects--some old fav's from out of print books and some wonderful new projects! If you can make it into the store, I'm sure you will enjoy seeing the actual quilts and projects.

Last, but not least, become a fan of Great American Quilt Factory on Facebook for a chance to win a $25 gift certificate. We have already given away 2 and are giving away at least one more when we reach our 1000th fan. Go to Great American Quilt Factory and click on "Like" at the top of the page next to our name. Good Luck!

Happy stitching,

Lynda

Christmas with Possibilities Surprise

Nancy and I got a package in the mail today and a special delivery for each of us at the store!

Here is what was in the package--our newest book Christmas with Possibilities published by C&T. It is truly a lovely book filled with 16 holiday projects--some old fav's from out of print books and some new wonderful projects! I'm ready to jump right in since it is May and we are already receiving Christmas 2010 fabrics.

A little bit later, we each got one of these...................

.................a beautiful basket filled with flowers!

Thank you to all at C&T who helped bring this book to print. We always enjoy working with all of you and you truly bring out topnotch products!

Thank you for a wonderful surprise!

Lynda and Nancy